Do it yourself four wheeled bike

PEDALS

Pedals are made of stainless steel 12 mm stick bended by local locksmith.

We mount it on the chassis with two pieces of steel 40x5 mm (U), where we drilled a 12 mm hole.

To make chain running parallel with the front gear, move the right side of pedals a little back (d2 > d1), so there is a right-angle between the pedals and the longitudinal profile (A). You will have to file holes in (U) because of it.

Pedals of Do it yourself four wheeled bike

Pedals posision of self made four wheel bicycle

Click image to enlarge - do it yourself four wheeled bike

Use some lock washers between pedals and (U) to prevent moving pedals left-right.

This sites are just information about what we did. The vehicle is not done by any safety standards and can be life dangerous when producing or using it. You are free to use our design and ideas in part or in whole, but you do it absolutely on your own risk and responsibility!
If using it commercial, you must cite the source: "Designed by www.spiller.si":

INTRODUCTION
DIMENSIONS
CHASSIS FRONT WHEELS
REAR WHEELS
STEERING
STEERING WHEEL
PEDALS
FRONT GEAR
REAR GEAR
SEAT
BREAKS
LINK
OTHER LANGUAGES